![background image](http://html.mh-extra.com/html/d-link/airpremier-dwl-7100ap/airpremier-dwl-7100ap_manual_78304064.webp)
64
1.
Check that the
Ethernet LED
on the DWL-7100AP is
ON
. If the
LED
is
not
ON
, check that the cable for the Ethernet connection is securely
inserted.
Check that the Ethernet adapter is working properly. Please see
item 3 in this section:
Check that the drivers for the network adapters are
installed properly
.
Check that the
IP address
is in the same range and subnet as the
DWL-7100AP. Please see
Checking the IP Address
in Windows XP
in
the
Networking Basics
section of this manual.
Note: The IP address of the DWL-7100AP is 192.168.0.50. All the computers on the network
must have a unique IP address in the same range, e.g., 192.168.0.x. Any computers that
have identical IP addresses will not be visible on the network. They must all have the same
subnet mask, e.g., 255.255.255.0
Do a
Ping test
to make sure that the DWL-7100AP is responding. Go
to
Start
>
Run
>Type
Command
>Type
ping 192.168.0.50.
A successful
ping will show four replies.
Troubleshooting
This Chapter provides solutions to problems that can occur during the installation and
operation of the DWL-7100AP Wireless Access Point. We cover various aspects of the
network setup, including the network adapters. Please read the following if you are
having problems.
Note: If you have changed
the default IP address, make
sure to ping the correct IP
address assigned to the
DWL-7100AP.
Note: It is recommended that you use an Ethernet connection to
configure the DWL-7100AP.
The computer used to configure the DWL-7100AP cannot access the
Configuration menu.