D-Link DGS-1016T/DGS-1024T Unmanaged Gigabit Ethernet Switch
vii
Safety Instructions (continued)
•
Move products with care; ensure that all casters and/or stabilizers are firmly connected
to the system. Avoid sudden stops and uneven surfaces.
General Precautions for
Rack-Mountable Products
•
Observe the following precautions for rack stability and safety. Also refer to the rack
installation documentation accompanying the system and the rack for specific caution
statements and procedures.
•
Systems are considered to be components in a rack. Thus, "component" refers to any
system as well as to various peripherals or supporting hardware.
CAUTION:
Installing systems in a rack without the front and
side stabilizers installed could cause the rack to tip o ver,
potentially resulting in bodily injury under certain
circumstances. Therefore, always install the stabilizers
before installing components in the rack.
After installing system/components in a rack, never pull
more than one component out of the rack on its slide
assemblies at one time. The weight of more than one
extended component could cause the rack to tip over and
may result in serious injury.
•
Before working on the rack, make sure that the stabilizers are secured to the rack,
extended to the floor, and that the full weight of the rack rests on the floor. Install front
and side stabilizers on a single rack or front stabilizers for joined multiple racks before
working on the rack.
