![D.E. Systems BL 500 Owner'S Manual Download Page 18](http://html.mh-extra.com/html/d-e-systems/bl-500/bl-500_owners-manual_495064018.webp)
18
INSTALLING REMOTE RECEIVER
1. Leave the Launcher in the open position to
prevent it from popping open during the instal-
lation, and position the Launcher so that the
Easy-Load™ trap door is to your left.
2. Hook the Connecting Wire to the bottom hole
of the Release Arm on the Launcher so that
the Connecting Wire is lying against the
Launcher itself. (see
Figure 1
)
3. Move the Motor Arm on the Remote Receiver
so that it is pointing toward the side of the Re-
mote Receiver that has the screw holes.
4. Hook the other end of the Connecting Wire to
the last hole on the Motor Arm (see
Figure 2
)
and point the Motor Arm down.
5. Line up the Remote Receiver to the holes on
the Launcher (the black prongs on the back of
the Remote Receiver should fit into the bottom
two holes of the Launcher). (see
Figure 3
)
6. Holding the Remote Receiver against the
Launcher, insert the screws that were included
with the Remote Receiver and tighten so that
the Remote Receiver fits snugly against the
Launcher.
7. Program the Remote Receiver to the Trans-
mitter (see p.13) and test to verify successful
programming (see p.15).
These directions are for adding a Remote Receiver unit
to a Manual-Release Launcher or replacing a Remote
Receiver unit on a Remote Launcher.