3
Installation of the Cutter
Insert the handle base into the handle
as shown.
Warning:
Do not put your fingers
against the sharp edge of the blade at
any time.
Changing the Blade
Use the provided Allan wrench to
remove the four screws, then hold the
blade by each end and carefully move
the blade out of blade holder.
Note:
the flat side of the blade facing
the table.
Warning:
Do not put your fingers
against the sharp edge of the blade at
any time.
Cut
Insert material between the cutting
blade and the base, flush with the
gauge as shown and hold the material
then push handle down to complete a
cut.
