4
Changing the Nylon Bar
Use the
provided Allan wrench
to remove the five screws, then
hold the nylon bar and carefully
move it out of nylon bar holder.
Warning:
Do not put your
fingers against the sharp edge
of the blade at any time.
Transport
Hook up the lock ring as
shown to the hook on the
eccentric cam and carry the
cutter as shown.
Changing the Blade
Use the
provided Allan
wrench to remove the five
screws, then hold the blade
by each end and carefully
move the blade out of blade
holder.
Note:
the flat side of the blade
should face the table.
Warning:
Do not put your
fingers against the sharp edge
of the blade at any time.