11 of 17
D. After both actuator’s metal doors have been properly secured to the housing, connect the
motor and the encoder connector of both actuators (as shown in drawing below). You should
hear a click when the connector is fully inserted. Finally, assemble and secure the access cover,
there is one (1) screw on each side and two (2) screws on the rear. Note that the screws
attaching the rear cover passes through the actuator metal door.
8- D-BOX 2250i/2400i Electrical diagramm
Note: Each time you will power-up the motion seat you will hear the motors locking themselves
up. This usually takes a few seconds unless the piston of either actuator has not been pulled in
completely at the last shutdown.
