10 of 17
7- Connecting the actuators to the ACM (Actuator Control Module)
IMPORTANT NOTICE
A. The connections between the ACM and the actuators must be done correctly in order for the
system to work properly. The exact position of each actuator in regards to the seat is indicated on
a sticker located on the top of the ACM unit. This sticker indicates if it is a left or right actuator.
See drawing below for more details;
: Before doing any connection into the ACM unit
make sure there is no
power by detaching the A/C cord
. There is high voltage inside the ACM unit, and only service
qualified technician are allowed to do the connections.
B. In order to connect each actuator into the ACM unit, you need to take the
ACCESS COVER
off
by removing the Philipps screws holding it in place and lifting it gently toward the
back. You
also
need to locate
all of the
Philipps screws
(10)
that are included in the package.
Removing ACM’s access cover
C. Pass the cable assembly of each motor through the proper ACM housing hole (making sure
the actuator is at the proper position in regards to the sticker) and secure the metal door using
two (2) Philipps screws supplied in the package (start by the two (2) screws at the bottom of the
metal door). See drawing below;
Making connections into the ACM unit
