3
EP series
Safety Precautions
Keep these instructions. Read these instructions.
Heed all warnings. Follow all instructions.
The exclamation point within an equilateral triangle is intended to alert the user of important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.
Where the amplifier is mounted in a rack and permanently connected to the mains, then the rack should be installed with a readily
accessible connector or an ALL POLE circuit breaker with 3mm breaking distances.
The mains switch on the amplifiers only switches one pole of the mains supply, therefore for units with a detachable cord to be fully
disconnected from the mains, the mains disconnect device (ie mains plug or mains coupler) should remain readily operable. For
units with a fixed mains lead the external all pole circuit breaker with 3mm breaking distances is the disconnect device and therefore
the installation of the amplifier shall be carried out in accordance with all the applicable installation rules.
Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles and the point where they exit
from the apparatus.
Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as if
the power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been dropped.
The mains circuit breaker shall remain readily accessible.
To completely disconnect this equipment from the AC mains, disconnect the power cord from the mains circuit breaker.
This unit is fitted with a 3-wire power cord. For safety reasons, THE EARTH LEAD SHOULD NOT BE DISCONNECTED UNDER ANY
CIRCUMSTANCES.
Take into account that the nominal AC voltage is the value shown in the equipment ±10% (according to IEC 60065:2001).
Unplug this apparatus during ligtning storms, earthquakes or when unused for long periods of time.
Do not install near any heat sources such as radiators, stoves or other apparatus that produce heat. Do not block any ventilation
openings, install in accordance with the manufacturer's instructions.
The cooling fans push cool air through one side and blow hot air out of the other side of the unit through the ventilating grilles.
Do not block the sides of the amplifier (i.e. in a rack with grilles). Allow an air flow gap of 5cm or more on the sides. IF THE AIR IS NOT
ALLOWED TO CIRCULATE, OVERHEATING WILL OCCUR.
Take care when mounting other equipment in the same rack.
Working temperature ranges from 15ºC to 45ºC with a maximum relative humidity of 75%.
Do not expose this device to rain or moisture. Do not use this apparatus near water (for example, swimming pools and fountains). Do
not place any objects containing liquids, such as bottles or glasses, on the top of the unit. Do not splash liquids on the unit. IP-20
equipment. Clean only with a dry cloth. Do not use any solvent based cleaners.
This symbol on the product indicates that this product should not be treated as household waste. Instead it shall be handed over to
the appicable collection point for the recycling of electrical and electronic equipment.
Only use attachments/accessories specified by the manufacturer. Use only with the cart, tripod, bracket or table specified by the
manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid
injury from a tip over.
WARNING: To prevent injury, this apparatus must be securely attached to the rack in accordance with the installation instructions.
The connected outer wiring to these terminals requires of its installation by an instructed person and the use of a flexible cable already
prepared.
The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence if uninsulated
“dangerous voltage”. To reduce the risk of electric shock do not remove the cover. No user serviceable parts inside.
WARNING: Apparatus with CLASS I construction shall be connected to a MAINS socket outlet with a protective earthing connection.
EP series /
User’s Manual
