20
DISPLAY (only
ALTEA-718A
)
Manual del Usuario
/ altea series /
User’s Manual
1 2
loud
AlTop
0.0m
O
0 dB
By default the state of the screen is the following:
As stated previously by pushing the encoder the
user can access the following options in the MENU:
Two factory settings (
loud and deep)
depending on the type of music/use has
With the encoder go to Preset Sub-menu and press
the knob to access the different options:
By scrolling down the encoder more options
appear:
MAIN MENU
MAIN MENU
MAIN MENU
MAIN MENU
MAIN MENU
MAIN MENU
MAIN MENU
MAIN MENU
BACK
BACK
BACK
BACK
BACK
BACK
BACK
BACK
PRESET: loud
PRESET: loud
OPTIONS: off
LPF: AlTop
LPF: AlTop
LPF: AlTop
LPF: AlTop
Delay: 0.0m
After having set the input volume values under
the maximum level, user has to adjust ouput
careful not to exceed the limit: (LIMIT shown)
After these two volume adjustments the screen
will show something like this (when having the input
sources ON):
loud preset
PRESET:
l
oud >
PRESET:
<deep
PRESET:
loud
PRESET:
loud
PRESET:
loud
Note: to enter and select and option always push the
select
Back
in the screen and press the encoder or just
1 2
loud
AlTop
0.0m
O
0 dB
1 2
loud
AlTop
0.0m
O
0 dB
INPUT
CLIP
C
1 2
loud
AlTop
0.0m
O
0 dB
1 2
loud
AlTop
0.0m
O
0 dB
LIMIT
L
LPF (Low Pass Filter):
Once the input source has been connected to the
amplifier´s cabinet, the user has to check the gain
structure of the system.
Adjust level output from your processor and/or mixing
console in order to prevent INPUT CLIP (left signal
meter):
ADJUSTING THE LEVELS
There are 3 different options:
LPF:
<AlTop>
LPF:
<63Hz>
LPF:
<100Hz
Combination with ALTEA-412A/415A
and ALTEA-712A/715A
Exceeding the limits may
cause damage in the system
Exceeding the limits my
cause damage in the system