Both PL-48S_1 pieces must now be
attached (5) to the box on the bottom by means of two
safety pins on each side.
Now the entire cluster can be lowered so
the PL-48S_1 pieces get into reach of the platform.
The next step is to fix the PL-48S_2 pieces to
the rear rigging hardware of the box. In order to do so,
the platform should be raised up (6) till the bottom hole
in the rigging hardware and the hole in the PL-48S_2
match together. Then the safety pins can be inserted
(7) in the holes. As has been said before, the splay
angle between the platform and the box is given by
the hole used in the PL-48S_2 piece.
The hole chosen in this example, is the one
on the bottom of the PL-48S piece, being 0º the angle.
66
Aero-38
Manual del usuario/
User´s manual
4
3
5
PL-48S_1
PL-48S_2
7
6
At this point the PL-48S_1 and the PL-48S_2
pieces are both connected to the box. There is only the
PL-48S_1 piece left to be attached to the platform.
Move the platform upwards till the holes in the PL-
48S_1 piece and the holes in the platform match
together. Then insert the safety pins (8).
