3
Congratulations on your purchase of a D.A.C.E gate operator. D.A.C.E has proven to be a leader in
the automation field and strives to manufacture high quality products using the latest technology
available. D.A.C.E. is constantly working on upgrading their products to bring you, the customer, a
product of the highest quality. Other products manufactured by D.A.C.E. include:-
•
Swing gate operators:
DuraSwing
•
Infra-red safety beams:
DuraOptics
•
Remotes and receivers :
DuraTronic
•
Slide gate operators:
SOLO 500; CONDO & CONDO AC/DC
•
Vehicle detection loop:
DuraLoop
It is recommended that an experienced gate installer is used to install your gate operator. If you intend
installing this operator yourself please read this manual carefully before any installation begins.
D.A.C.E has taken all reasonable steps to ensure that the gate operator is safe to install and use.
However it must be remembered that a gate is a heavy piece of moving equipment and may cause
serious damage or injury if the gate strikes an object or person. The gate operator has built in collision
sensing electronics. Having struck an object the gate will stop and reopen, however this does mean
that the gate will physically strike the object before it stops. It is therefore strongly recommended that
DuraOptics
infrared safety beams are installed to reduce the risk of the gate striking an object.
Note:
The installation of beams does not guarantee against the gate striking an object in its path.
Ensure the following items are checked before any installation is done
:
•
The rail is level – the gate must not move on its own at any stage.
•
The wheels are turning freely and are not jammed.
•
The gate is not bent or bowed in any way.
•
The rail has sufficient end stops so that the gate can never run off the end of the rail.
•
The portal is constructed in such a way that the gate can not fall over.
•
The rollers are turning freely and are not jammed.
•
The anti lift device is sufficient in order to stop the gate from being lifted off the rail.
•
The gate mass or start-up force does not exceed the maximum as stated in the specifications.
•
The gate does not jam in the catch bracket when closing or opening.
•
Extreme care should be taken when automating a gate that is constructed out of any solid type
of material such as wood, as wind resistance can cause over current problems.
•
The gate must not exceed the maximum number of operations stated in the specifications.
If any of the above points are not satisfactory do not install the operator until all the points are rectified.
Remember that if a gate causes damage or injury due to faulty installation then the installer of the
equipment will be held liable.
•
It is recommended that your local E.C.A. (Electrical Contractors Association) is contacted in
order to obtain the legal wiring regulations pertaining to the area.
•
Electrical Shock may occur while installing this equipment.
••••
Injury or death by electrocution may lead to law suits against the installer/homeowner.
•
If you intend to run 230V/AC directly from the Mains supply (house supply) to the transformer,
the wiring should be done by a qualified/registered electrician. This is a legal requirement and
failure to do so may lead to non-compliance of property or law suits against the property owner
in the event of an accident.
INTRODUCTION, RECOMMENDATIONS & LEGAL REQUIREMENTS
