17
VERY IMPORTANT: GEARBOX MUST BE FILLED WITH THE SUPPLIED OIL BEFORE
COMMISSIONING THE OPERATOR.
FILLING THE GEARBOX OIL
The gearbox oil level needs to be topped up
periodically. Remove the oil level screw and
add oil until the oil just starts to run out of the
hole.
REPLACE THE SCREW!!!
Oil level screw
Use S.A.E.75W/90 oil to refill the gearbox
Fill the gearbox as shown bellow. The entire
bottle (70ml) needs to be emptied into the
gearbox.
SETTING THE MOTOR DIRECTION
When programming the operator the gate must always move to the closed position first. If the operator
opens first, reverse the motor direction by swopping the motors wires as per below and then
reprogram the operator.
PROGRAMMING THE OPERATOR
To program the operator follow the steps below.
1.
Remove all power from the main PC Board.
2.
Manually open the gate 1m -1.5m (this will be the pedestrian opening distance).
3.
Engage the gearbox.
4.
Switch dipswitch 1 on.
5.
Apply battery power only. The Open, Close and Status LEDs will flash rapidly.
6.
Press “TEST” button.
7.
The gate
MUST
drive to the CLOSED end stopper and then drive to the OPEN end stopper
(the LEDs will remain flashing).
Swop the Blue/Black motor
wires to change the motor
direction.
Main
PC Board
Continued on pg. 18
