Product User’s Manual –
1.0 INTRODUCTION
SHIELD-MD10 is an Arduino shield for controlling high current brushed DC motor up to
10A continuously. It is compatible with
,
and possibly other pin compatible main boards. SHIELD-MD10
uses full solid state components which results in faster response time and eliminates the wear
and tear of the mechanical relay. SHIELD-MD10 shield has stackable side headers which
allows for more Arduino shields to be stacked on top of it.
SHIELD-MD10 Shield come with these features:
●
Bi-directional control for 1 brushed DC motor.
●
New!!
Support motor voltage ranges from 7V to 30V.
●
Maximum current up to 10A continuous and 15A peak (10 seconds).
●
3.3V and 5V logic level input.
●
Solid state components provide faster response time and eliminate the wear and tear
of mechanical relay.
●
Fully NMOS H-Bridge for better efficiency and no heat sink is required.
●
Speed control PWM frequency up to 10KHz.
●
Stackable I/O header pin.
●
Selectable digital pins for PWM and DIR.
Note: Please note that there will be only Shield MD10 Rev 2.0. There is an improvement
made in Shield MD10 Rev 2.0. For Shield MD10 Rev 2.0, "SHIELD-MD10 R2" is labelled
at the front and back of the shield like shown in the figure.
Created by Cytron Technologies Sdn. Bhd. – All Right Reserved
3
