Cyrus Stream Xa, User Instructions

Page: 18 / 25

Stream Xa User Instructions
16
SetUP MenU
the Setup menu enables you to change settings of your
Stream Xa to best match your system and listening
preferences.
to reach the setup menu
Press and hold the • key to return to the Main Menu.
Select the Setup option from the Main Menu. •
The setup menu will open and the sub-options will be
displayed.
Setup - Network Settings - DHCP Settings
the factory default network settings of the Stream Xa (dhcP
enabled) should be compatible with most modern cabled or
wireless networks.
it should not therefore be necessary to change the
network settings of a Stream Xa unit, unless you know that
your network has been configured to require Manual ip
addresses.
If this is the case, you should only proceed to change the
network settings if you fully understand Manual ip address
assignment, and know a free ip address that can be allocated
to the Stream Xa . Assigning an existing ip address to the
Stream Xa may cause conflicts with other network devices.
Note: these settings can only be changed from the front
panel controls.
Select the Network Settings option from the Setup •
menu.
The Network Menu will be displayed. The DHCP Settings
option
Select the DHCp Settings option from the Network •
Settings menu.
The DHCP menu will be displayed.
Select the ‘off’ option to change to manual ip •
assignment.
enter the IP address in the format nnn.nnn.nnn.nnn
•
using the keys listed to follow.
Press the
• key repeatedly to switch character set
entry between
Numeric entry •
Lower case alphabet •
upper case alphabet •
punctuation and other symbols •
oK (select this option when you have finished entering •
the IP address).
space.
•
Delete (select this option to delete the last character •
you entered).
turn the Volume/select control to change the character •
displayed.
press the Volume/select control to add each character to •
the address displayed.
When you have completed entry of the IP address, select
•
the ‘oK’ option from the list above.
The display will now prompt for a Subnet Mask.
Follow the same procedure to enter the Subnet Mask in •
the same format.
The display will now prompt for a Gateway address.
follow the same procedure to enter the gateway address •
in the same format.
The display will now prompt for a DNS1 address.
follow the same procedure to enter the dNs1 address in •
the same format.
The display will now prompt for a DNS2 address.
If you want to enter a dNs2 address, follow the same •
procedure to enter the dNs2 address in the same
format.
if you don’t want to enter a DNS2 address, select ‘oK’ to •
bypass this setting.
Once the last entry is completed, the Stream Xa will re-start
and join the network using these settings.
NOTe: If a Stream Xa set to Manual IP is connected to a
different network these settings must be changed, or DHCp
re-enabled, depending on the network requirements.