Cyrus DAC XP Signature, User Instructions

Page: 18 / 21

Cyrus DAC XP Signature User Instructions
16
Input names
Input name
Input 1
DVD
< >
When the DAC XP Signature leaves the factory, the input
names are set to correspond to the rear panel connections,
for example Input 1 will display as Input 1.
The name of any input may be changed to a choice from the
following list-
No source (off)* •
LaserDisc, DVD, DVD 2, DVD-A, CD, CD 2 •
Linkserver, Linkport •
Jukebox, Phono •
Tuner, DAB, TV, AV, Cyrus AV*, Satellite, Satellite 2, •
Cable
Video, VCR, VCR 2, Tape, MiniDisc, DAT
•
PC, Games, Keyboard, Aux, AV Direct*, Stream X. •
To change the names of the inputs, we recommend making
a list of each input number with your preferred name from
the choices above before setting the names.
There are three special function input names marked *.
‘No source’ is used to name inputs which have no source
connected to them. These input numbers will not then
appear in the input selector sequence.
‘Cyrus AV’ is reserved for the connection of Cyrus surround
sound decoders. When a cyrus surround decoder is
connected to an analogue input named ‘Cyrus AV’ the DAC
XP Signature will check the system for the presence of a
Cyrus surround decoder and, if found, lock out its volume
control at a precise setting. Normal volume operation will
be restored when any other input is selected.
‘AV Direct’ is reserved for the connection of non-Cyrus
surround decoders to an analogue input. This input name
must only be used for this purpose as the volume level
will lock to a very high setting (-6dB) when AV Direct is
selected.
Input trims
Offset
Input 7
+4dB
It is possible to adjust the sensitivity of analogue inputs 7
and 8 by selecting the appropriate trim option from the
menu. This enables the volume level when playing low
or high output source components such as tape decks or
tuners to be equalised with the digital system sources.
Restoring factory settings
You can also restore all configuration options to the initial
default settings that were applied at the factory.
NOTE: This operation is not reversible.
To restore factory settings, disconnect mains power from
the unit. Now re-connect mains power while holding down
the Standby key.