Cyrus DAC XP Signature, User Instructions

Page: 15 / 21

Cyrus DAC XP Signature User Instructions
13
Learning TV and Satellite commands
In addition to controlling Cyrus components, the remote
control can learn the commands from two other remote
control handsets. These will normally be a TV and a Satellite
or terrestrial TV set-top box, programmed to the TV and
SAT buttons, but could also be other audio components
including a cyrus tuner or dVd player etc.
All keys may be programmed with the exception of the
groups marked CONTROL and SOURCE and the SETUP key.
Preparation for learning
Check the following points before attempting to learn any
commands -
Check that both remote controls have fresh batteries. •
Choose a location on a tabletop that is not brightly lit. •
Subdued light is better, away from bright natural or
indoor lighting.
Check that you have enough time to spare to complete
•
the learning process for all the keys you want to use.
Learning commands
In this example, the Cyrus remote control will be learning
commands from a ‘reference’ Satellite receiver remote
control.
Set the two remote controls up facing each other, spaced 1.
by about 5cm.
1 2 3
4
5
7 9
6
8
0/10
SAT TV
STORE
MENU
ENTER
SELECT
LIST
CH
SETUP
abc def
ghi jkl mno
pqrs tuv wxyz
GUIDE
INF
O
TEXT
TV/AV
CONTROL
SOURCE
1 2 3
4 5
7 9
6
8
0/10
SAT TV
STORE
MENU
ENTER
SELECT
LIST
CH
SETUP
abc def
ghi jkl mno
pqrs tuv wxyz
GUIDE
INF
O
TEXT
TV/AV
CONTROL
SOURCE
The keypad will light and the key you selected will be red.
Press the TV or 2.
sAT key to select
the mode that you
want to program.
Press and hold the 3.
seTuP key.
The mode key will change to white. After about three
seconds, the mode key will light red again. This indicates
that the remote control is ready to learn codes.
Release the seTuP key. 4.
The remote control is now waiting to learn commands. The
keypad will light continually and the mode key will light pale
red.
On the reference remote control, press and hold the first 5.
key you want to learn (for example, volume up) until the
mode key flashes red.
This indicates that the command has been received.
Release the key on the reference remote control. 6.
Press a key on the Cyrus remote control (volume up 7.
in this example) to select where you want to save that
command.
The mode key will stop flashing. This indicates that the
command has been saved successfully.
If the learning process was successful, the remote control
will be ready to learn the next command.
Repeat steps 5 to 7 for each command you want to 8.
learn.
When you have completed learning all commands -
Press the seTuP key. •
The mode key will change to white. After a few seconds the
backlight will switch off.
1
2
3
4
5
7
9 6
8
0/10
SA
T
TV
ST
OR
E
MENU ENTER SELECT
LIST
CH
SETU
P
abc
def
ghi
jkl
mn
o
pqrs
tuv
wxyz
GU
ID
E
IN
FO
TEXT
TV/
AV
CONTRO
L
SOURC
E
1
2
3 6
5
4 7
8
9
0
AUDI
O
SUB
TTX
GUIDE
FA
V
INFO
TV/
R
OK
LIST
EXI
T
AD
ZOOM MENU
VOL
CH
5cm