Setup and Verification
S6SAL211A31SA2001, S6SAL211A31SA3001 4ch 72W LED Driver and Communication Board Operation Guide, Document Number: 002-08632 Rev. *B 13
*1: Connect LED to all CH from CN_101 to CN_401. Refer to Figure 4-3.
*2: S6SATU03 can provide power to DALI communication lines from CN_DALI. This current limit is 50 mA (Supply voltage
= 12V-20V).We must consider this current when determining the number of connected DALI Slave. We have to select
the cable in consideration of the rated current and then rated voltage
*3: Beforehand, make a setup of PC and install software.
*4: A board of S6SAL211A31-DALI-SA2 is possible to buy as single item. (Part Number: S6SAL211A31SA2001)
Figure 4-3 Connection of 6SAL211A31-DALI-SA2 and LED
*1: Connect LED to all CH from CN_101 to CN_401. LED module(I
F
≥
1A, V
F
≈
3.2V, 5- series ) Be careful about polarity.
*2: Thermistor (THp,THm) is an option. Even if that isn't connected, a board operates.
4.2.3 GUI Control Function When Using S6SATU03
4.2.3.1 Preparing the Control GUI
Run DALI communication software (S6AL211_DALI_GUI.exe) after connecting the USB cable.
Show the message box below if the connecting GUI and DALI controller is success.
Otherwise, check USB cable connection or installation of the device driver.
THm
THp
LEDm
LEDp
CN_101
S6SAL211A31-DALI-SA2
CN_401
LED,Thermistor
(*1)
(*2)
THm
THp
LEDm
LEDp
THm
THp
LEDm
LEDp
THm
THp
LEDm
LEDp
(*1)
(*2)
CN_201
CN_301
