Setup and Verification
S6SAL211A31SA2001, S6SAL211A31SA3001 4ch 72W LED Driver and Communication Board Operation Guide, Document Number: 002-08632 Rev. *B 12
4.2.2 Operation Check When Using S6SATU03
WARNING
Do not look directly at LED. There is a possibility that your eye is hurt.
1. Connect CN_101,201,301,401 of S6SAL211A31-DALI-SA2 and LED by connection cable. *1
2. Connect CN_DALI of S6SATU03 and CN_DALI of S6SAL211A31-DALI-SA2 by DALI cable. *2
3. Connect CN101 of S6SATU03 and PC by USB cable. (LED101 near CN101 of S6SATU03 on board will shine in red.)
4. Run DALI communication software.
5. 24Vdc is applied to CN_VIN of S6SAL211A31-DALI-SA2.
6. LED of all channel are lighting. (Bright level is set POWER ON LEVEL of DALI command)
7. Send DALI command DAPC to BROADCAST ADDRESS from S6SATU03. You can control LED brightness. (Look at
"Control Lighting by the broadcast")
Figure 4-2 Board Connection
GUI
S6SATU03
S6SAL211A31-DALI-SA2
PC (*3)
LED,
Thermistor (*1)
24Vdc
Power
supply
USB cable
DALI
communication
line (*2)
(No Polarity)
LED,Thermistor cable
×
4ch
CN101
CN DALI
CN DALI
CN_VIN
CN_101
CN_201
CN_301
CN_401
S6SAL211A31-DALI-SA2 (*4)
Maximum DALI LIghting module (slave) number is 64.
CN DALI
CN_VIN
CN_101
CN_201
CN_301
CN_401
24Vdc