HX3 Kits User Guide, Doc. #: 001-91203 Rev. *D
35
Kit Operation
You can configure HX3 on the CY4603 board using the following procedure:
1. Power off the CY4603 board by disconnecting the AC-DC power adapter from the DC jack.
2. Enable configuration using pin straps by installing a jumper on pins 1 and 2 of PIN_STRAP_EN
(J13 on CY4603).
3. Remove the jumper on VID_SEL[0] to retain the Cypress VID. Note that the DS4_GRN LED func-
tionality will be void in this configuration.
4. Configure the required pin straps by installing the jumpers as required. Refer to
for
more details.
5. Power the CY4603 board.
6. Verify the configuration implemented using the pin straps.
VID_SEL[0]
Selects the vendor ID.
Reserved
VID_SEL[1]
VID_SEL[2]
I2C_DEV_ID
Sets the I
2
C slave address for the
HX3 hub controller when it is con-
nected to an external processor.
0xB0 0xC0
Table 3-8. Implementation of Pin Straps on CY4603 Hardware
(continued)
Pin Strap Name
Description
Strapped to Logic '1'
(Jumper on Pin 1 and 2)
Strapped to Logic '0'
(Jumper on Pin 2 and 3)
Summary of Contents for CY4603
