PSoC 6 WiFi-BT Pioneer Kit Guide, Doc. # 002-22677 Rev. *B
6
1.
Introduction
Thank you for your interest in the CY8CKIT-062-WiFi-BT PSoC 6 WiFi-BT Pioneer Kit. The PSoC 6
WiFi-BT Pioneer Kit enables you to evaluate and develop your applications using the
.
The PSoC 6 MCU is Cypress’ latest, ultra-low-power PSoC specifically designed for wearables and
IoT products. It is a programmable embedded system-on-chip, integrating a 150-MHz Arm
®
Cortex
®
-M4 as the primary application processor, a 100-MHz CM0+ that supports low-power
operations, up to 1 MB Flash and 288 KB SRAM, CapSense
®
touch-sensing, and programmable
analog and digital peripherals that allow higher flexibility, in-field tuning of the design, and faster
time-to-market.
The PSoC 6 WiFi-BT Pioneer board offers compatibility with Arduino™ shields. The board features a
PSoC 6 MCU, a 512-Mb NOR flash, an onboard programmer/debugger (KitProg2), a 2.4-GHz
WLAN and Bluetooth functionality module (CYW4343W), a USB Type-C power delivery system (EZ-
PD™ CCG3), a five-segment CapSense slider, two CapSense buttons, one CapSense proximity
sensing header, an RGB LED, two user LEDs, USB host and device features, and one push button.
The board supports operating voltages from 1.8 V to 3.3 V for the PSoC 6 MCU.
The CY8CKIT-062-WiFi-BT package includes a CY8CKIT-028-TFT Display Shield that contains a
2.4-inch TFT display, a motion sensor, ambient light sensor, a 32-bit audio codec, and a PDM
microphone.
This is the first kit that enables development of PSoC 6 MCU + WiFi applications. To develop a
PSoC 6 MCU + WiFi application, WICED™ Studio 6.1 or later must be used. WICED Studio is
Cypress' integrated development environment (IDE) for developing WiFi applications. If you are not
adding WiFi to your design then you can develop and debug PSoC 6 MCU project using PSoC
Creator™. PSoC Creator supports exporting your designs to other third-party firmware development
tools.