PSoC 6 WiFi-BT Pioneer Kit Guide, Doc. # 002-22677 Rev. *B
26
WICED
Figure 3-2. Creating New Make Target
4. Enter
snip.scan-CY8CKIT_062 download_apps download run
in the
Target name
field
and click
OK
.
Note:
The list of all commands that can be provided in the Make target is listed in
<WICED-SDK
installation directory>/ 43xxx_Wi-Fi/Makefile
.
snip.scan-CY8CKIT_062 download_apps download run
indicates the following:
a.
snip
= Directory inside
apps
folder
b.
scan
= Sub-directory and name of the application to be built. For example, to build the con-
sole application under test directory in apps, then use
test.console
instead of snip.scan.
c. CY8CKIT_062 = Board/platform name
d. download_apps = Download application resources into QSPI Flash
e.
download
= Indicates download to target
f.
run
= Resets the target and starts execution
5. Double-click (alternately, right-click and select
Build Target
) the
Clean
Make Target to remove
any output from the previous build. It is recommended to do Make clean when any new files are
added or removed to the corresponding Target.
Note:
Before executing the next step, ensure that you connect the CY8CKIT-062-WiFi-BT kit to
the same PC through the Type-C USB cable connected to the J10 port. See
tion and Programming Modes of KitProg2
to ensure that the kit is successfully enumerated and
Port Selection
is set to CMSIS-DAP mode.