
Cypher Technology Ltd V2.6 (03) December 2011
6
3 Quick Start Guide
3.1
Turning On
1. Connect the supplied 12V 5A power supply (PSU) lead to rear panel power inlet and
screw up the connector. Connect the PSU to a mains supply using the supplied
cable.
2. Remove any flash card.
3. Switch on the Power Switch on the rear panel (switch up). The display panel will
light up and show “Press I/O”. The green front panel LED will flash.
4. Press the I/O (On/Off) switch below the green flashing LED. “On..” will be displayed
and the green LED will be on constantly.
5. After a few seconds, a growing line of dots will appear on the display and the system
will be ready for use after about 20 seconds.
3.2
Making Master and Working Copies of a Flash Card
1. Check that the displayed time and date are correct.
2. Insert the flash card into the appropriate front panel slot. The display will show the
card’s size and number of files. A USB stick may be plugged into one of the USB
sockets on the rear panel or front panel (M1.3 only).
3. Press the Disk button to eject the disk tray. Place a BD
(1)
, DVD or CD in the tray.
4. Press the TRANSFER button to start the transfer.
a) A Master copy is produced first. This consists of the transfer of the data from the
card to the disk and a verification read pass. On successful completion the Master
disk will be ejected and the checksum of the flash card and disk will be shown. This
can be noted down for future reference. Where multiple disks are needed, follow the
on-screen instructions and note down the separate disk checksums as well as the
final checksum for the card and whole backup.
b) Remove the Master Copy disk and place a new disk on the tray. Press the lower
soft key marked “Continue” to proceed. The Working copy is now produced. On
successful completion the disk(s) will be automatically ejected.
c) The flash card may now be wiped and re-formatted. Press “N” when prompted if
this is NOT required.
The Transfer is complete.
Note: If further copies are required, do not wipe the card, and use the appropriate
functions available in the “Menu”. Press “Menu” soft key and the Up/Down cursor keys.
3.3
Turning Off
Press the I/O button below the green LED to shutdown. When “Switch Off” is displayed,
turn off the rear panel Power Switch.