5
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Front Panel
SERVICE
POWER
A
B
1080P
XGA
IN 1
IN 1
IN 2
IN 3
IN 4
MENU
-
+
ENTER
IN 2
IN 3
IN 4
OUT
VIDEO
MODE
A
B
OUT
1
2
3
4
5
6
7
8
9
1
SERVICE Port:
This port is reserved for firmware update and user EDID/
logo upload use only.
2
POWER LED & Button:
Press this button to power the multiviewer
component of the unit on (green LED) or place it into stand-by mode (red
LED).
Note: Ethernet and RS-232 remain active when the unit is in stand-by
mode. Does not affect the video capture component of this unit.
3
VIDEO MODE Button:
Press this button to sequentially switch the
multiviewer component’s operational mode between Matrix, PiP, PoP,
and Quad.
4
OUT A~B/IN 1~4 LED Array:
In Matrix mode, these LED’s indicate the
currently selected sources (IN 1~4) routed to each of the two outputs
(OUT A~B). When the multiviewer component is in a multi-windowing
mode (PiP/PoP/Quad/ Preset) all LEDs will be illuminated simultaneously.
Note: When source selection is active the associated output’s LED(s) will
blink.
5
OUT A/B Buttons:
In Matrix mode, either of these buttons to activate/
deactivate discrete source selection for the associated output. In multi-
windowing modes (PiP/PoP/Quad/Preset) either button will activate/
deactivate sequential source selection for the 4 windows.
Note: These buttons only activate/deactivate the ability to change
sources. Actual source selection is accomplished using the IN 1~4
buttons.