CYP EL-8500VA, Operation Manual

Page: 41 / 88

41
■ MIC Gain:
Sets the microphone input’s volume level when the
microphone is an active audio source (mixed or unmixed).
■
Output Mixer: Set the microphone mixing mode of the unit
– Mixer Off:
Disable the audio mixer.
– Mixer On: Enable the audio mixer. Audio from the current
source and the microphone will be mixed together.
– MIC Only:
Output only the microphone audio source. This
mode will override all other audio selections.
Note: Activating Mixer On mode, or MIC Only mode will automatically
disable HDMI Out Bypass mode.
■ HDMI Out Bypass (audio only):
Enable or disable HDMI audio
bypass mode. When enabled, all audio will automatically behave
as if in “Follow Video” mode and bitstream audio can be supported.
Note: This bypass setting affects audio only.
■ Audio Routing:
Use the dropdown to select the audio routing
behaviour of the unit.
– Follow User: Audio routing will follow the selections made in
the “Follow User Setting” section.
– Follow Video:
All digital sources will use their native
embedded audio content. VGA 1 will use the Analogue 1 audio
input and VGA 2 will use the Analogue 2 audio input.
– Fixed Analogue 1~6: Forces all video sources to be paired
with the selected analogue audio source.
Note: When HDMI audio Out Bypass is enabled, all audio will
automatically behave as if in “Follow Video” mode.
2) Follow User Setting: These routing settings are only enforced when
Audio Routing has been set to “Follow User”.
Note: Not active when HDMI audio Out Bypass is enabled.
■
Set Video and Audio Source: Buttons for defining the audio
routing to use when the “Follow User” mode is enabled. To begin
assigning a new audio route, select one or more video sources
on the left, then select the audio source to route with them on
the right. As you select each button they will change their colour
to orange. The new routing information will be displayed on the
Video Source buttons after selection.