3
6.2 Rear Panel
HDMI IN
1
2
3
4
5
6
7
8
HDMI OUT
DC 5V
SYS
RESET
ON OFF
SERVICE
EDID
STD TV
1 2
3
4
5
6
1
SYS RESET ON/OFF:
When switched ON (default setting is off) the
unit will, every 8~10 minutes, automatically switch all connected
displays to their HDMI Input 1.
Note: For this feature to function connected displays must support
CEC commands.
2
EDID STD:
When in 'STD' mode, the unit will use its own built-in EDID
settings. In this mode, the video output will be set to 1080p@60Hz
and the audio output at LPCM 2CH Stereo. Use this mode if there
are display problems in TV Mode.
EDID TV
:
When in 'TV' mode, the unit will read the EDID settings of
the display device connected to HDMI OUT 1. If it detects a 4K2K
capable EDID setting it will transmit the signal in that format to
all outputs. If no 4K2K capable EDID is detected then the unit will
output the best resolution that all displays can support.
Note: The unit will retain and use the EDID settings of the last device
connected to the HDMI OUT 1 output if no device is connected to
this output even after switching EDID modes or a power cycle.
3
SERVICE:
Manufacturer use only.
4
HDMI IN:
Connect the input port to the HDMI or DVI output of your
source device such as a DVD player or set-top box with an HDMI
cable.
5
HDMI OUT 1~8:
Connect each of the HDMI outputs to an HDMI
display for simultaneous HDMI distribution, or cascade the output
to another transmitter to extend the operating distance.
6
DC 5V:
Plug the 5V DC power supply into the unit and connected
the adaptor to an AC outlet.
