CYP COH-TR7, Operation Manual, Page: 16 / 32

11
2) DP HDCP: Set the HDCP behavior of the DisplayPort input.
■ Follow In: The input supports up to the HDCP version
required by the connected source.
■ Follow Out: The input supports up to the HDCP version
supported by the connected display.
■ Disable: HDCP support is completely disabled.
■ Follow API: Uses the HDCP setting defined by the IP Master
Controller or control software.
Note: Follow API is not valid in a Point-to-Point configuration.
DEVICE SETTING
2ND LEVEL
3RD LEVEL
Status TRANSMITTER
Receiver
Fan Mode FOLLOW TEMP
Always On
USB Control Mode Host
DEVICE
USB Virtual Hub
(USB Device Mode only) On
OFF
Input INPUT 1
Input 2
Input 3
(Receiver Mode only)
Local Priority HDMI
DP
OFF
1) Status: Set the operational mode of the transceiver. After changing
the operation mode, the unit will automatically reboot.
2) Fan Mode: Set the fan’s activation behavior. Selecting “Follow
Temp” will result in the fan only turning on if the internal
temperature becomes too high.