CYP CH-352TX, Operation Manual, Page: 16 / 36

11
6.5.2 Network Tab
The Network tab provides control over this transmitter’s IP configuration.
Changes made to the network settings will require a reboot of the unit. After
clicking on “Apply” please follow the reboot instructions in the WebGUI.
Note: If the IP address is changed then the IP address required for WebGUI
and Telnet access will also change accordingly. If the new address is
assigned via “Auto IP” or “DHCP” it will be necessary to obtain the newly
assigned IP address by checking Device Discovery app, or the unit’s OSD
display.
1) IP Setup: This section allows for configuration of the IP acquisition mode
and Ethernet settings of the unit. It also provides an easy way to find the
physical unit when installed with many other similar units.
„
IP Mode & Settings: The IP mode may be switched between “Auto
IP”, “DHCP” or “Static IP”. When the unit is set to Auto IP mode it
will automatically assign itself an APIPA address from the 169.254.
xxx.xxx range. When the unit is set to DHCP mode it will attempt to
automatically obtain an IP address from a DHCP server. When the IP
mode is set to static IP, you can manually set the IP address, netmask
and gateway address. Click the “Apply” button to save changes made
to the IP Mode or Configuration.
Note: The default network setting for this unit is “Auto IP”. If the unit
is set to “DHCP” but no DHCP server can be found, the IP mode will
temporarily switch to “Auto IP” until the unit is rebooted.