14
2) USB over IP (Receiver 1 Only):
This section provides control over the
USB over IP extension functionality.
■
Enable USB over IP: Unchecking this checkbox will completely
disable support for USB streaming to this unit. This option should
generally remain checked, but, if USB support is not required,
disabling this feature can save some bandwidth.
3) Serial over IP (Receiver 1 Only):
This section provides controls for the
serial over IP extension functionality, including setting the RS-232 data
configuration.
■ Enable Serial over IP:
Unchecking this checkbox will completely
disable support for serial streaming to this unit. This option should
generally remain checked, but, if serial support is not required,
disabling this feature can save a very small amount of bandwidth.
■ Serial Settings:
Set the desired baud rate, data bits, parity, and stop
bit for the RS-232 signal to extend.
Note: The transmitter and receiver must have the same serial settings.
4) Reboot:
Pressing this button will force the unit to reboot.
6.6 Telnet Control
Before attempting to use Telnet control, please ensure that both the unit and
the PC are connected to the same active networks.
Start your preferred Telnet/Console client, or use the built in client provided
by most modern computer operating systems. After starting the client,
connect by using the current IP address of the unit and port 23 (if the
communication port number used by the unit has not been changed
previously). This will connect us to the unit we wish to control and commands
may now be entered directly.
Note 1: If the IP address of the unit is changed then the IP address required
for Telnet access will also change accordingly.
Note 2: By default the unit is set to “Auto IP” mode. The current IP address
can be obtained by using the Device Discovery app, or by checking the
OSD info screen when there is no live video connection. The default
communication port is 23.
