12
Note: The default network setting for this unit is “Auto IP”. If the unit
is set to “DHCP” but no DHCP server can be found, the IP mode will
temporarily switch to “Auto IP” until the unit is rebooted.
■ Find Your Device:
Selecting “Show Me” will cause the unit to
immediately begin flashing the LEDs on the front of the unit to make
it easy to find. Selecting “Hide Me” returns the LEDs to their normal
behavior. This setting is useful when troubleshooting an installation
with a large number of units in a rack.
2) Reboot:
Pressing this button will force the unit to reboot.
6.5.3 Functions Tab
The Functions tab provides control over the receiver’s AV output
management, streaming activation, as well as defining how USB and serial
signals are handled (receiver 1 only). The available controls are different
depending on whether you are connected to receiver 1 or 2. Changes made
to these settings may require a reboot. Please follow the reboot instructions
in the WebGUI, if necessary.
1) Video over IP:
This section allows control over enabling/disabling the
AVoIP stream, the scaler/output resolution, and the behavior upon signal
loss.
