DRAFT
2
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Transmitter Front Panel
RS-232
IR OUT
POWER
LINK PAIR SEL
FUNC
RESET
LINK
1
ON
2 3 4
2
3
4
5
6
7
1
1
Power LED:
The LED will illuminate when the device is connected
with power.
2
LINK LED:
The LED will illuminate when the Transmitter is linked with
Receiver.
3
RS-232:
This slot is to connect with D-Sub 9-pin female null modern
cable from PC’s system for controlling both the input source and
output display over RS-232.
4
IR OUT:
This slot is to connect with IR Blaster cable included in the
package for IR signal sending and controlling the HDMI input
source equipment.
5
LINK PAIR SEL:
This dip switch allows user with matrix setting for link
up to 16 pairs of the devices with single IP router. Each pair must
have the same dip switch setting in order to pair to the right device
setting. The factory default setting is at 0000.
6
RESET:
Use nail to push the button inside the box to repower ON the
device.
7
FUNC button:
Hold this button still and powering ON the devices,
when both link LED and power LED twinkling, press reset button
and release FUNC button. This will reset Transmitter back to factory
default setting.
