Action
Possible causes
Problem
See the section Settings.
Incorrect rinse aid dosage setting.
Spots or films on the dishes.
Wash crystal at a low temperature and
with a conservative amount of detergent.
Contact the detergent manufacturer.
Too high temperature and/or too much
detergent can cause etching on crystal.
Unfortunately, this cannot be repaired,
only prevented.
Reduce the amount. See the sections
Before washing for the first time and
Settings. If you have very soft water, you
may want to dilute the rinse aid 50:50
with water.
Rinse aid dosage setting too high.
The dishes have a sticky white/blue film.
Use a detergent with a bleaching agent.
Lipstick and tea can be difficult to wash
off.
Spots left after washing.
The detergent compartment must be dry
when adding detergent.
The detergent compartment was damp
when adding detergent.
Detergent residue in the detergent com-
partment after dishwashing.
Check that the dishes are placed se-
curely. Spin the spray arms to make sure
they can rotate.
The dishes are not correctly placed or
the spray arms are not rotating.
Rattling sound when dishwashing.
No action. The programme time is stored
and next time the programme is run the
corrected time will be displayed.
The programme is taking longer than
estimated.
1 minute appears in the display.
Clean the coarse and fine filters.
The filters are blocked.
Water remains in the dishwasher.
Clean the drainage pump. See the sec-
tion Care and cleaning.
Debris in the drainage pump.
Check that the hose is free from kinks
and sharp bends.
Kink in drainage hose.
Disconnect the drainage hose where it
connects to the sink unit's water trap.
Check that no debris has fastened and
that the connection has an inner diamet-
er of at least 14 mm.
Blocked drainage hose.
Clean with washing-up brush and low
foaming cleaner.
Dirt around the seals and in corners.
Bad odour in dishwasher.
Run a programme with a higher temper-
ature about once a month.
Low temperature programmes have
been selected for a prolonged period.
Activate the Auto open option.
The Auto open option is not activated.
The dishes are not dry enough.
Fully load the dishwasher.
The dishwasher is not fully loaded.
Top up with rinse add or increase the
rinse aid dosage. See the sections Be-
fore washing for the first time and Set-
tings.
Rinse aid needs topping up or dosage
is set too low.
36
Summary of Contents for SV-DISK 3R
Page 1: ...SV DISK 3R...
Page 22: ...Egna noteringar 22...
Page 43: ...Your notes 43 EN...
Page 44: ...Your notes 44...
