Operating Instructions | GPM 450 SPEED
24
Fig. 27: “PROGRAM SAVING AND LOADING”
Screen
Press
SAVE
if you have your job ready and wish to save it. In the
JOB NAME
field you may enter up to 24
characters to name the program you wish to save. The field changes along with the program number.
Press
OK
to go back to the “SETTING” screen. The program is saved and displayed on the “SETTING”
screen.
Load the program in a similar manner. Use
+
and
-
to choose a saved program you wish to load. Press
LOAD
. Press
OK
to go back to the “SETTING” screen. The number of the loaded program is displayed
next to the
PROGRAM
field. The machine is ready to operate according to this program.
Warning: The touch screen displays the number of the last program saved or loaded. For the sake of
effectiveness, the operator can change this program by a different program without saving it. In such case,
the number of the last program saved or loaded is still displayed, but the machine operates according to the
operator’s last setting, even though this setting has not been saved. If the machine is turned off and then
turned on again by the electric switch, the machine operates according to the program displayed on the
touch screen. The last unsaved setting is deleted.
8.7 Starting Working Cycle
Adjust the feeding table (1) according to the instructions in Section 7.2. There must be minimum gap
between the side guides and the pile of paper. The machine is constructed for pile of paper 50 mm high.
Press the table release (15). Paper is pushed into the feeding head (10). Lower the paper brake (7) onto
the end of paper. Adjust the distance of the back stop (11) on the delivery table (2) according to the size of
the sheet.
Press
START
on the touch screen (Fig. 20). The machine starts running and the touch
screen switches to the “WORKING CYCLE” screen (Fig. 28). The
STOP
icon
and information about the
program, the batch and the number of processed sheets are displayed on the touch screen.
