EN-12
EN-13
Operating the device
Operating the device
Recalling saved measurement values
The thermometer has a measurement value memory with 30 save
slots. The measurement values are saved automatically together with
the date and time of the measurement. The most recently measured
value is stored in save slot 1; the value measured prior to that is stored
in save slot 2, and so on. If more than 30 measurements are taken,
the oldest value (no. 30) is deleted so that the most recent value (no.
1) can be saved.
The measurement values and lots of additional information are saved
in the mySense app, where they can be analysed with ease.
You can also recall the last 30 readings directly from the mySense ba-
sal body temperature thermometer. To do so, proceed as follows:
• With the device switched off, press and hold the
memory recall button for at least 5 seconds
until the icon appears on the display. The de-
vice switches to memory mode (Figure 1).
• The most recently meas-
ured value, no. 1, is now
displayed (Figure 2, Figure
3). The display switches
between the measure-
ment value and the year,
month/day and time. For
measurement values that have been transferred to the mySense
app, the symbol is displayed.
• By repeatedly pressing the memory recall
key , you can call up the previous measure-
ments (no. 2, no. 3 ...).
• If no measurement values are saved, the fol-
lowing appears on the display (Figure 4):
Figure 3
Figure 2
Figure 1
Figure 4
• If the device cannot establish a connection, the measurement value
is stored on the device to be transferred later. The device can tem-
porarily store up to 30 measurement values. The thermometer then
switches itself off (Figure 12).
Establishing a data connection to the mySense app
The thermometer automatically synchronises the measurement val-
ues, as well as the date and time, to the mySense app after each meas-
urement.
If you want to synchronise the thermometer to the mySense app with-
out performing a temperature measurement, proceed as follows:
• With the device switched off, press and hold the data transfer but-
ton for at least 1 second, but no more than 5 seconds, until the
Bluetooth symbol appears in the display. If
you hold down the button for more than 5
seconds, you will enter memory recall mode.
• The device now connects to the app via Blue-
tooth (Figure 1).
• If the connection is successful, the “APP” indi-
cator appears and the display lights up green
(Figure 2).
Figure 1
Figure 2
If the device cannot connect to the mySense
app, it switches itself off after 60 seconds. If this
occurs, check whether Bluetooth is enabled on
your smartphone and that the mySense app is running, then try again.