8
A red lamp will light up on the charger indicate the battery is charging. When the red light
turns green, the battery is fully charged. To optimize battery life, leave the charger
connected for a further hour and then turn off the charger and disconnect it from the
mains after charging. Always disconnect the charger from the mains before disconnecting
the charger from the battery. It is possible that the battery will take up to twelve hours to
charge on the first three charges.
2.4.2 When charging the battery, always do so in a well ventilated area.
2.4.3 Do not leave the charger connected to the mains when not in use.
2.5
Water
2.5.1 Your electric bicycle is rain and splash proof and can be used in all weathers.
2.5.2 The electrical components of the bicycle, such as motor, battery, and controller, must not be
submerged in water.
2.5.3 Do not directly flush the bike with water to avoid direct contact with the brake levers,
handlebars, electronic equipment, etc., causing hidden dangers of the accident.
2.5.4 Please use neutral detergent, wipe the headlight lampshade, instrument case and other
plastic parts with a soft clean cloth or sponge dipped in water, and then wipe with a dry cloth
to avoid scratches;
2.5.5 It is strictly forbidden to refuel the front and rear brakes and tires;
2.5.6 Please avoid frequent bike washing, the best bike washing cycle is 10-20 days, too frequent
will accelerate the aging of bike paint;
2.5.7 To protect the environment, please try to wash the bike in the place where the sewer pipe is
laid to prevent the road area water from affecting the traffic safety.
2.6
Maintenance and adjustments
2.6.1
IMPORTANT!
Do not attempt to open the casings of the battery, motor or controller. It
could be dangerous and all warranties will become void. If you experience a problem,
contact our service department or the retailer.
2.6.2 Wheel spokes should be checked after 300 miles of riding. Handlebar and saddle tubes
should never be raised beyond the maximum permissible, indicated by a safety line around
the tubes. The recommended torque (tightness) of crucial fixings is as follows: