CYBEX 530T, Owner'S Manual

Page: 47 / 66

Cybex Pro
3
Treadmill Owner’s Manual
Setup
and
Assembly
Page 5-1
5 - Setup and Assembly
Warnings/Cautions
All warnings and cautions listed in this chapter are as follows:
! WARNING: Use extreme caution when assembling the treadmill. Failure to do so could
result in injury.
! CAUTION: A minimum of two people are required to lift, move and assemble this treadmill.
Always use proper lifting methods when moving heavy items.
! CAUTION: Do not pinch your hands or other body parts while pivoting the treadmill.
See Figure 3.
! CAUTION: During this procedure STAY OFF THE RUNNING BELT! Stand with your feet
on the two steps.
Choosing and Preparing a Site
Before assembling the treadmill you must select a suitable site and have the proper electrical outlet
power available for optimum operation and safety. See the Electrical Power Requirements section
(located on the next page) for direction in locating your treadmill's voltage requirements.
The area you select for the treadmill should be well lit and well ventilated. Locate the treadmill on a
structurally sound and level surface (do not place in recessed areas or on plush carpet) a few feet away
from walls and other equipment. Each side of the treadmill should have a 19.7” (0.5 m) minimum space.
Behind the treadmill should be 79” (2.0 m) minimum of space. Allow enough clearance for safe access
and passage during use of the machine. If the treadmill is to be located above the fi rst fl oor, place it near
or above major support beams. If the area has a heavy, plush carpet, the airfl ow around the base of the
machine may be restricted or the carpeting may interfere with the moving parts. To protect the carpeting
and the machinery, place a 3/4” (1.9 cm) thick wood base under the treadmill.
Do not install the treadmill in an area of high humidity, such as in the vicinity of a steam room, sauna,
indoor pool, or outdoors. Exposure to extensive water vapor, chlorine, and/or bromine could adversely
affect the electronics as well as other parts of the machine.