INSTALLING YOUR UPS SYSTEM - continued
the unit will emit one long beep. To correct
this, turn the UPS of and unplug at least
one piece of equipment from the battery
power supplied outlets. Make sure the
circuit breaker is depressed and then turn
the UPS on.
8. To store the UPS for an extended period,
cover it and store with the battery fully
charged. While in storage, recharge the
battery every three months to ensure
battery life.
9. Ensure the wall outlet and UPS are located
7. To maintain optimal battery charge,
leave the UPS plugged into an AC outlet
at all times.
near the equipment being attached for
proper accessibility. near the equipment
being attached for proper accessibility.
BASIC OPERATION
1. Power Switch
Used as the master on/of switch for
equipment connected to the battery
power supplied outlets. (Please refer
to the Function Setup Guide for more
information.)
2. Power On Indicator
This LED is illuminated when the utility
power is normal and the UPS outlets are
providing power, free of surges and spikes.
3. LCD module display
The LCD display shows all the UPS
information using icons and messages.
For more information please review the
“Defnitions for Illuminated LCD Indicators”
section below.
4. LCD Display Toggle/Selected Switch
The switch can be used to select the LCD
display contents including Input Voltage,
Output Voltage, and Estimated Run Time.
The toggle frequency is set to one time
per second.
5. USB Charging Ports
The USB Charging ports provide 5V 2.1A
power output.
6. Battery and Surge Protected Outlets
The UPS has fve battery powered/
surge suppression outlets for connected
equipment to ensure temporary
uninterrupted operation of your equipment
during a power failure. (DO NOT plug a
laser printer, paper shredder, copier, space
heater, vacuum, sump pump or other
large electrical devices into the “Battery
and Surge Protected Outlets”. The power
demands of these devices may overload
and damage the unit.)
7. Full-Time Surge Protection Outlets
The UPS has fve surge suppression outlets.
8. Circuit Breaker
Located on the back of the UPS, the circuit
breaker serves to provide overload and
fault protection.
9. USB Ports to PC
The USB port allows connection and
communication between the USB port on
the computer and the UPS unit.
10.Communication Protection Ports
Communication protection ports will
protect any standard modem, fax,
telephone line, network or Ethernet
connection (RJ11/RJ45).
11. Wiring Fault Indicator (red)
This LED indicator will illuminate to warn
the user that a wiring problem exists, such
as bad ground, missing ground or reversed
wiring. If this is illuminated, disconnect
all electrical equipment from the outlet
and have an electrician verify the outlet is
properly wired. The UPS will not provide
surge protection without being plugged
into a grounded and properly wired wall
outlet.
12.Coax/Cable/DSS Surge Protection
The Coax/Cable/DSS protection ports will
protect any cable modem, CATV converter,
or DSS receiver.
13. Outlets Designed for AC Adapters
The unit has two outlets spaced to allow
AC power adapter blocks to be plugged
into the UPS without blocking adjacent
outlets.