Copyright © 2012 CyberPower Systems, Inc.
IMPORTANT SAFETY INSTRUCTIONS
1
Save These Instructions! This manual contains important constructions that shall be followed during the installation and maintenance of the
CyberPower On-grid Solar Power Generating System.
CAUTION!
Before installation and using the On-grid Solar Power
Generating System, read all instructions and cautionary markings
on the On-grid Solar Power Generating System and appropriate
sections of this guide.
CAUTION!
To reduce risk of fire hazard, do not cover or
obstruct the heat sink.
CAUTION!
Observe the clearance recommendations. Do not
install the On-grid Solar Power Generating System in a
zero-clearance or non-ventilated compartment. Overheating may
result.
CAUTION!
Use only accessories recommended or sold by the
manufacturer. Doing otherwise may result in a risk of fire, electric
shock, or injury to persons.
CAUTION!
To avoid a risk of fire and electric shock, make sure
that existing wiring is in good condition and that wire is not
undersized. Do not operate the On-grid Solar Power Generating
System with damaged or substandard wiring.
CAUTION!
Do not operate the On-grid Solar Power Generating
System if it has received a sharp blow, been dropped, or
otherwise damaged in any way.
CAUTION!
Do not disassemble the On-grid Solar Power
Generating System. It contains no user-serviceable parts.
Attempting to service the On-grid Solar Power Generating System
yourself may result in a risk of electrical shock or fire and will void
the factory warranty.
CAUTION!
To reduce the risk of electrical shock, disconnect
both AC and DC power from the On-grid Solar Power Generating
System before attempting any, maintenance or cleaning or
working on any circuits connected to the On-grid Solar Power
Generating System. Turning off controls will not reduce this risk.
Internal capacitors remain charger for 2 minutes after
disconnecting all source of power.
CAUTION!
The On-grid Solar Power Generating System must be
connected to an equipment-grounding conductor directly or via
the AC ground.
ATTENTIO:
Risk of burning: During operation the case
temperature may exceed 140
℉
(60
℃
) , do not touch.
HIGH VOLTAGE:
Before opening the device, disconnect from
the grid and the PV generator. The device may only be opened by
an electrician.
WARNING!
Require PV modules that have IEC 61730 class A
rating.
The following conventions are used in this guide.
WARNING!
Warnings identify conditions that could
result in personal injury or loss of life.
CAUTION!
Cautions identify conditions or practices that
could result in damage to the unit or other equipment.
IMPORTANT:
These notes describe things which are important
for you to know, but not as serious as a caution or warning.
About This Manual
This purpose of this Installation & Operation Manual is to provide
explanations and procedures for installing, operating, maintaining,
and troubleshooting the CyperPower On-grid Solar Power
Generating System.
Scope
This manual provides safety guidelines, detailed planning and
setup information. It provides procedures for installing the
On-grid Solar Power Generating System and information about
operating and troubleshooting the unit. It dose not provide
details about particular brands of photovoltaic (PV) panels. You
need to consult individual PV manufacturers for this information.
Audience
This manual is intended for anyone who needs to install and
operate the On-grid Solar Power Generating System. Installers
should be fully educated on the hazards of installing electrical
equipment.
Certified
electricians
or
technicians
are
recommended.
Abbreviation and Acronyms
AC:
Alternating Current
DC:
Direct Current
LCD:
Liquid Crystal Display
LED:
Light Emitting Diode
MPPT:
Maximum Power Point Tracking
PC:
Personal Computer
!
!
Summary of Contents for CPSPV2000ETL-IN SLV
Page 2: ...www cpsww com ...
