Setting Up the V3 Paging Server
Configure the Device Parameters
CyberData Corporation
930427L
Operations Guide
21
Note
You must click on the
Save
button and then the
Reboot
button for the changes to take
effect.
2.4.4.1 Polycom Paging
The Paging Server supports Group Paging Mode on Polycom IP phones using UC Software 4.0.0
and higher.
Polycom phones use the same multicast IP address and port number for both PTT and Group
Paging multicasts. Make sure to note the Polycom multicast IP address and port number before
configuring the CyberData V3 Paging Server. Polycom phones use a default multicast IP address of
224.0.1.116 and odd-numbered port 5001.
While the same multicast IP address and port number is used for all Polycom pages in both modes,
Polycom uses numbered "groups" or "channels" to differentiate between each paging group. Each
"group" or "channel" is numbered 1 through 25.
Enable Polycom Paging on Multicast
When selected, a Polycom Group Paging multicast will be sent to the
specified Paging Group multicast address and [port 1]. The
Polycom Group Paging multicast will be transmitted as a second, separate
multicast transmission in addition to the standard multicast transmitted to the
specified multicast address and even numbered port for the desired Paging
Group (PGROUP). Be sure to configure an odd numbered port for the
Polycom Paging/PTT Configuration setting on the Polycom phones.
CyberData PGROUPS configuration settings are located on the
PGROUPS
Configuration Page
. The Polycom Paging/PTT Configuration setting for the
multicast IP address on the Polycom phones must match the Paging Group
multicast IP address on the Paging Server's
PGROUPS Configuration
Page
.
Note
:
Enabling Polycom Paging
will result in a standard RTP multicast
being sent to the specified address and port and a Polycom PTT Page
mulitcast being sent to the specified address and [port 1].
Polycom Transmit Channel
Specify the Polycom channel/group number. Group Numbers 1 through 25
are supported. The Polycom phones must subscribe to this channel/group
number to receive pages from the Paging Server.
Click on the
Save
button to save your configuration settings.
Note
: You need to reboot for changes to take effect.
When the
Test Audio
button is pressed, you will hear a voice message for
testing the device audio quality and volume.
When the
Test Multicast
button is pressed, the Paging Server will send a
five second canned ULAW message to a predetermined multicast address
and port.
Note
:
Test Multicast
will send a 5 second ULAW multicast stream to
234.2.1.200:2200.
Click on the
Test Relay
button to do a relay test.
Click on the
Reboot
button to reboot the system.
Table 2-6. Device Configuration Parameters (continued)
Web Page Item
Description
