CYBELEC CybTouch 8 G, User Manual

Page: 21 / 40

15/34
CybTouch 8 G – User Manual
A
ug
.
2016
V3.1
Back gauge button
The back gauge can be activated/deactivated using this icon. When activated, the Back
gauge position is displayed, allowing the operator to program it according to his needs.
Back gauge position
This value determines the physical position of the X axis, or back gauge. It is a sequence
parameter. Its display depends of the setting of User Preference
Length Units (see
page 6) .
The back gauge can be deactivated for cuts which do not require a back gauge. It is thus
sent to its parking position. The
Back gauge position is no longer displayed.
This parameter is only available if the back gauge is activated (see Back gauge
button ).
Extra Cutting
Features Depending on the configuration of the machine, there can be various other optional
features to help the operator to perform tasks. They are located in the lower half of
the screen, whether it be the
Program Page (see page 14) or the EasyCut Page (see
page 25) .
Blade gap
This function may not be available on your machine, and depends on its type and
configuration.
This icon and the value below represent the blade gap. In general it cannot be changed
and is calculated automatically according to the
Material and Material thickness (see
page 20) . On some machines however the value can be modified by the operator within
a limited tolerance.
For more information about the blade gap’s default values and tolerances, refer
to chapter
Materials, page 7 .
Pressing two seconds will enable the relative positioning. A first absolute sequence must be programmed before.