CV2
Function
CV2 is preprogrammed for Note-On Velocity but can be reprogrammed, see the following
section Functions for CV Outputs . CV2 is pre-patched for amplitude control but can be de-
selected by a switch under the AMP-CV section. Default sensitivity is 100% but can be altered,
see CV Gate/Trig Configuration below.
Connections
CV2 is accessible from both the front and rear panels, see the figures above. CV2 can also be
substituted by an external control voltage via an input on the front panel under ’AMP-CV’
section.
CV3
Function
CV3 is preprogrammed for Control Change #1, Modulation Wheel messages, but can be
reprogrammed to react on any MIDI message, see Parameter Programming below.
CV3 is pre-patched for Fixed Modulation CV Select for LOWPASS FILTER and MULTI-MODE
FILTER frequency corner modulation. Default sensitivity is 100% but can be altered, see CV
Gate/Trig Configuration below.
Connections
CV3 is accessible from both the front and rear panels, see the figures above.
CV4
Function
CV4 is preprogrammed for Channel Aftertouch messages, but can be reprogrammed to react
on any MIDI message, see Parameter Programming below.
CV4 is pre-patched for Fixed Modulation CV Select for LOWPASS FILTER and MULTI-MODE
FILTER frequency corner modulation. Default sensitivity is 100% but can be altered, see CV
Gate/Trig Configuration below.
Connections
CV4 is accessible from both the front and rear panels, see the figures above.
CV5
Function
CV5 is preprogrammed for Control Change #5, Portamento (Glide) Time, but can be
reprogrammed to react on any MIDI message, see Parameter Programming below. Default
sensitivity is 100% but can be altered, see CV Gate/Trig Configuration below.
Connections
CV5 is not accessible as an output.
CV6
Function
CV6 is preprogrammed for Pitch Wheel messages, but can be reprogrammed to react on any
MIDI message, see Parameter Programming below. CV6 is prepatched to the Master Controller
for modulation of oscillator pitch and frequency corners of the filters. Default sensitivity is set
to ±24 semitones but can be set anywhere between ±1-24 semitones in semitone steps, see
CV Gate/Trig Configuration below.
Connections
CV6 is not accessible as an output.
28
