4.5. The “Orientation”
state
T
he STATUS LED is ON, press
will at laser orientation state, and if you
want to quit, just keep on press
in 3 seconds, then the mini cutter will be
at working state.
4.6. Laser Orientation cutting and contour cutting
Take CorelDraw program as example:
①
Please create more than two pictures layers in CorelDraw software, and
make the picture and the orientation sign at a layer, make contour in
another layer.
②
Send the pictures and orientation sign layer to the printer for printing.
③
press
button, the STATUS LED will ON, then press
button,
now the cutter at Laser Orientation state. At this moment, the carriage will
move from right to left, and will have a laser dot shoot out on the paper from
right side to left, you need to move the paper by hand to check the original pot
④
Put down the handle to press on the paper, press
button in 5 seconds
in order to quit the orientation system, and get ready to receive the data
from computer.
⑤
Close the printing attribute for the image and sign in the CorelDraw
software, Send the vector contour layer to the mini cutter for cutting
Note:
1.The width of the curve must be very slim.(Even 1pt still can’t be output)
2.You must change the letter into curve when you want to cut letters, and make sure the
curve is slim enough!
3. Different cutters will have different orientation sign, so it needs to adjust.
4.CorelDraw is not special cutting software, have no sharp compensate function, so
maybe (there will ) not work well at the ling corner and the seal.
22
