3.4.
How to fix the blade holder or pen holder into the tool lamp
①
Turn off the cutter.
（
It is very important
）
②
Loose the screw, fix the blade holder or pen holder, when the sharp of blade
or the pen touch the Plastic Pressing strip, all is ok.
③
Tighten the screw in clockwise.
④
Turn on, you can see the sharp of blade or pen will rise up 2-3mm.
3.5. Testing
After fix blade (or Drawing pen ) and paper well, you can try to “Testing”
to
check the Force and the length of the blade ok or not
Steps
：
①
The STATUS LED will ON when Press
.
②
Press
button, the blade (or the pen) will draw the picture above for itself
testing.
3.6
The life of Blade
The correct usage could prolong the life of blade.
①
The more length the blade sharp extend out, the shorter life blade will work .
So you should avoid cut through the paper.
②
The more Force , the blade life will get short
③
Trying to use small Force, when the blade edge is getting less sharp, you
could add the working force suitable.
④
Different brand blades will have different life.
⑤
You should change the blade when you find the old one has no tartness, to
avoid affecting the work badly.
19
