SMART TRIPLE PLAY® Run Brake Turn Controller with
Built in Strobe/Flasher (Patent Pending)
Part: GEN-SMART-TPU-UNV
Fits: Universal 12VDC, Non CAN BUS Motorcycles
Important:
For this system to be legal you must use RED rear turn signal lamps.
Important: This system is designed to work with single intensity rear turn signals, if you
do not have single intensity rear turn signals do not install this module. Contact Techni-
cal Support.
Important: Remove any existing Run-Brake-Turn or similar modules prior to installing
this unit.
Caution: Never install a Load Equalizer Downstream of this unit. Remove any existing
load equalizer prior to installing this unit.
Caution: Never install a trailer adapter, trailer harness or trailer controller downstream
of this unit, a trailer adapter, harness or controller must be installed on the input side
of this unit.
Caution: This unit is designed for a maximum load of 27 watts per channel. Do no ex-
ceed 27 watts per left turn signal output, 27 watts per right turn signal output, and 27
watts per brake signal output. Overloading unit could cause damage to the unit and
cause the unit to malfunction.
1. Secure motorcycle on level surface. Remove seat. Disconnect negative battery ca-
ble from the battery. Locate and unplug the lighting connector to the rear fender.
2. Wire the Smart Triple Play® Module, in-line, into the rear lighting harness according
to the diagram on page 2 and 3.
3. Re-connect the battery’s negative battery cable to the negative of the battery.
4. Locate a secure place for the Smart Triple Play® unit that will not interfere with the
secure placement of the seat or side cover.
Installation Instructions
