SMART TRIPLE PLAY® Run Brake Turn Controller with
Built in Strobe/Flasher (Patent Pending)
7. The Smart Triple Play ® allows you to program the running light brightness of the turn signals so
they are a match to your center taillight.
•
Turn ignition key off, be sure Switch 1 and Switch 2 are in the OFF position and the Rotary Dial
in in the 0 position.
•
Turn ignition key on, immediately turn Switch 1 On Off On. Turn Switch 2 On OFF On. Turn the
Rotary dial one complete clockwise revolution back past position 0 and stop. Do not depress
Brake or Turns Signals during this action.
•
The turn signals should now fade up and down slowly, do not proceed unless this confirmation
takes place.
•
Turn the rotary dial clockwise, increasing numbers, to increase the brightness of the running
lights. Match the running light brightness to the taillight. Once happy with the setting, press and
hold the brake for a couple of seconds. The setting will now be saved.
8. Turn ignition key Off and set switches for desired Operation.
Switch 1 On, Switch 2 On: Strobes/Flashes on all three Rear Lights
Switch 1 On, Switch 2 Off: Strobes/Flashes on rear turn signals only
Switch 1 Off, Switch 2 On: Strobes/Flashes on center light only
Switch 1 Off, Switch 2 Off: No Strobes/Flashes
Rotary Switch Setting to set Brake Flash/Strobe Pattern:
Pattern 0: Four Flashes then Solid (Incandescent or LED)
Pattern 1: Four Flashes, Solid for 3 Seconds, Repeat (Incandescent or LED)
Pattern 2: Seven Flashes then Solid (Incandescent or LED)
Pattern 3: Seven Flashers, Solid for 3 Seconds, Repeat (Incandescent or LED)
Pattern 4: Quad Strobe then Solid for 1 Second then Quad Strobe (LED Only)
Pattern 5: Quad Strobe, Solid for 1 Second, then Quad Strobe, Solid for 3 Seconds, Repeat (LED
Only)
Pattern 6: Blaster X Pattern for 3 seconds, then Solid (LED Only)
Pattern 7: Constant Blaster X Pattern (LED Only)
Pattern 8: Constant Fast Strobe 5 Seconds, then Solid (LED Only)
Pattern 9: Constant Fast Strobe Pattern (LED Only)
9. Turn ignition key on and Test Operation based on your desired switch
settings.
10. Reinstall Seat.
Installation Instructions
