Custom Audio Electronics TPTCM, User Manual

Page: 40 / 124

3. PRINTER FUNCTIONS
TPTCM
16 3-
2 n 1 n A 5 $ B 1 $
[Name]
Sets the number of steps for form feed.
[Format] ASCII ESC Z n1 n2
Hex 1B 5A n1 n2
Decimale 27 90 n1 n2
[Description] When the printer receives an $0C character, or when the FF key is pressed, the paper
forward feeds until the photocell finds a reference point or up to the distance preset in the
Eeprom. The default value, which is 240 (30 mm), can be modified by the user. The
number of steps is given by (n1*256) +n2. The set value is stored in the Eeprom, and
continues to be stored even when the printer is switched off.
[Notes]
[Default]
[Reference]
[Example]
H n L n C 5 $ B 1 $
[Name]
Set relative print position
[Format] ASCII ESC \ nL nH
Hex 1B 5C nL nH
Decimal 27 92 nL nH
[Range] 0
≤
nL
≤
255
0
≤
nH
≤
255
[Description] Sets the print starting position based on the current position by using the horizontal or
vertical motion unit.
• This command sets the distance from the current position to [(nL+ nH
×
256)
×
(horizon-
tal or vertical motion unit)].
[Notes] • Any setting that exceeds the printable area is ignored.
• When the starting position is specified by
n motion units to the right:
nL + nH
×
256 = n
When the starting position is specified by n motion units to the left (negative direction),
use the complement of 65536:
nL + nH
×
256 = 65536 – n
• If setting exceeds the printing area width, the left or right margin is set to the default
value.
• In standard mode, the horizontal motion unit is used.
[Default]
[Reference]
[Example]
n 1 6 $ B 1 $
[Name]
Select justification
[Format] ASCII ESC a n
Hex 1B 61 n
Decimal 27 97 n
[Range] 0
≤
n
≤
2, 48
≤
n
≤
50
[Description] Aligns all data in one line to the specified position.
n selects the type of justification as follows: