Custom Audio Electronics tg2480h, User Manual

Page: 103 / 108

The following igure shows a section of the device with the paper path and the distances between the alignment sensor,
the printing head and the cutter (cutting line), where
A = distance between the alignment sensor and the printing line = 12 mm
B = distance between the printing line and the cutting line = 12.5mm
B A
CUSTOM/POS emulation
To deine the alignment point you need to set the device parameters that compose the numerical value of the “B. Mark
distance” parameter (see paragraph 6.4).
For example, to set a notch distance of 10mm between the notch and the alignment point, the parameters must be set on
the following values:
B. Mark distance [mm x 10] : 1
B. Mark distance [mm x 1] : 0
B. Mark distance [mm x .1] : 0
The “B. Mark distance” parameter, may be modiied as follows:
• during the Setup procedure of the device (see chapter 6)
• by using the 0x1D 0xE7 command (for more details, refer to the Commands Manual)
• by driver.
103