Custom Audio Electronics KM216H, Command Reference Manual

Page: 33 / 48

$1D $65
Printers: KPM216H
[Name]
Ejector commands
[Format] ASCII GS e n m
Hex 1D 65 n m
Decimal 29 101 n m
[Range] 1 ≤ n ≤ 6
[Description] This command checks tickets ejector
n = 1
n = 2 Ticket retracted (only if Paper retracting is enabled)
n = 3 Ticket produced with m steps (1 step = 6.5 mm)
n = 4
n = 5 Ticket ejection
n = 6 Transmit the status byte of the ejector
BIT OFF / ON HEX Decimal FUNCTION
0
Off 00 0 Paper present in abundance
On 01 1 Near paper end
1 - - - RESERVED
2
Off 00 0 Paper end sensor (paper not present)
On 04 4 Paper end sensor (paper present)
3
Off 00 0 Ticket not present on the output
On 08 8 Ticket present on the output
4
Off 0 Printer’s stepper motor off
On 16 Printer’s stepper motor on
5
Off 00 0 Emitter motor off
On 20 32 Emitter motor on
6
Off 00 0 Not error
On 40 64 Error
7
Off 00 0 Free paper route
On 80 128 Paper jam
[Notes] m must be sent with n = 3;
with n = 3 if the ticket is not yet cut, before to perform the command, the printer made a
total cut.
[Default]
[Reference]
[Example]
The correct commands sequence to print a ticket is:
1. Clear dispenser
Ejection (Hex : 1D 65 05) or Retraction
2. Prints ticket
3. Cuts paper
Total cut (Hex : 1B 69)
4. Dispenser
Presents ticket with ≈ 80mm (Hex : 1D 65 03 1E)
ESC/POS™ Emulation
Command Reference
33