GENERAL SPECIFICATIONS
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
2 - 2
2
2012 Shuttle 8 E
Released: 01/12/2012
Revised: 01/12/2012
Specifications are subject to change without notice
* Field installed accessories may require installation charges
MODEL: SHUTTLE™ 8
TYPE: ELECTRIC POWERED PERSONNEL CARRIER
MODEL YEAR: 2012
Part No:. 626500
Precision Drive System™ (PDS):
Factory programmable to application
z
Solid State continuously variable seperately excited speed controller
z
Eight, 6 Volt Deep Cycle
z
Dash mounted direction selector switch (Forward-Neutral-Reverse)
z
Full torque, reduced speed reverse
z
Anti-roll back, walkaway braking and alarm
z
Inductive throttle sensor
z
Anti-stall motor protection
z
Diagnostic indicator
z
Regenerative ’Pedal Down’ and/or ‘Pedal Up’ braking
Battery Charger:
Delta Q, 48 VDC. H120/230 VAC 50/60 Hz. Underwriters Laboratories (U.L.) Listed, (C.S.A. Certified)
Motor:
48 volt DC shunt wound, brazed armature, solid copper windings. Intermittant Horsepower 18.1 hp (13.5 kW) at 1900 rpm (1hour)
Drive Train:
Direct motor shaft connected to transaxle pinion shaft
Electrical System:
48 Volt DC, eight, 6 volt deep cycle storage batteries (107 minute, 225 amp-hour @ 20 hr. discharge rate)
Transaxle:
Differential with helical gears
Brakes:
4 Wheel Hydraulic Brakes, Front Disk, Rear Drum, Floor Mounted Manual set/released Park Brake w/ Warning Buzzer
Performance
Seating Capacity
8 Person using Flip/Flop (base config)
Seating Capacity option 6 Person using Cargo Deck w/ stake side
Dry Weight
1142 lb (519 kg) (Without Batteries)
Curb Weight
1632 lb (742 kg)
Cargo Deck Capacity
400 lb.
Vehicle load capacity
1600 lb (727 kg)
Outside Clearance Circle 33 ft (10.1 m)
Speed (Level Ground)
13 mph ± 0.5 mph (21 kph ± 0.8 kph)
Towing Capacity
N/A
Steering & Suspension
Steering
Self-compensating rack and pinion
Front Suspension
Leaf springs with hydraulic shock absorbers
Rear Suspension
Leaf springs with hydraulic shock absorbers
Service Brake
4 Wheel hydraulic Brakes, Disk/Front, Drum/Rear
Parking Brake
Floor Mounted Manual Set/Release w/Warning Buzzer
Front Tires
Kenda Load Star, 50 psi
Rear Tires
Kenda Load Star, 70 psi
Vehicle Power
Power Source
48 Volts DC
Motor Type
Shunt Wound
Continuous Horsepower (kW) 2.5 hp (1.9 kW)
Intermittent Horsepower (kW) 18.1 hp (13.5 kW) @ 1900 rpm
Electrical System
48 Volt
Batteries (Qty, Type)
Eight, 6 Volt Deep Cycle
Key or Pedal Start
Pedal Start
Battery Charger
48 VDC Delta Q, 120/230 VAC, UL & CSA
Speed Controller
400 Amp Precision Drive System (PDS)
Drive Train
Motor Shaft Direct Drive
Transaxle
Differential with helical gears
Gear Selection
Dash Mounted Forward-Neutral-Reverse
Rear Axle Ratio
14.7:1
Body & Chassis
Headlights
Halogen Headlights std
Brake Lights
Rear Brake lights std
Frame
Welded steel. DuraShield™ powder coat
Body & Finish
Injection molded TPO
Seat Pod
Fiberglass & Gelcoat
Standard Color
Hunter Green
Some items shown may be optional equipment
CONFIGURATION HIGHLIGHTS
PRODUCT SPECIFICATION
PRODUCT OVERVIEW
Overall Length
167.5 in (425.5 cm)
Overall Width
49.5 in (125.7 cm)
Overall Height (No Canopy)
45.5 in (115.6 cm) (Top of steering wheel)
Overall Height (With Canopy) 76.0 in (193 cm)
Wheel Base
123.4 in (313.7 cm)
Front Wheel Track
36.0 in (91.4 cm)
Rear Wheel Track
38.0 in (97 cm)
Gnd Clearance @ Differential 4.3 in (11 cm)
Dimensions
Noise & Vibration
Sound pressure; continued A-weighted equal to or less than 70 db(A)
The RMS value of weighted acceleration is less than 2.5 m/s
2
The RMS value of weighted acceleration is less than 2.5 m/s
2
The uncertainty of measurement is 0.69 m/s
2
Noise
Vibration, WBV
Vibration, HAV
Measurement methods were applied per the ISO 2631 and ISO 5349 standards under conditions of typical vehicle surfaces.
