![background image](http://html.mh-extra.com/html/curtis/1nhwm25sca/1nhwm25sca_installation-and-owners-manual_2700159015.webp)
CAB INSTALLATION
15 of 28
STEP 18: (FINISH HEATER)
18.1
Connect the leads found on the heater to the main
power wire harness (orange to orange, red to red &
black to black). See Figure 18.1.
18.2
Install the provided
13”
length of
1/2”
wire loom to the
heater leads.
18.3
Refill the cooling system. Start the tractor and inspect
coolant system for leaks.
18.4
With the tractor running, check the heater hoses and
make sure they get warm. If not, remove the heater
from its mount and let hang from the hoses as low as
possible. If the heater and hoses still do not get warm,
temporarily put a clamp on the upper radiator hose to
force coolant through the heater.
Warning:
To avoid
engine damage, remove the clamp as soon as heater
gets warm. Reattach heater to the bracket. Once
complete, let the engine cool, check the coolant level,
and top off coolant if required.
STEP 19: (FINISH WIPER)
19.1
Turn on the wiper motor briefly, then turn back off. This
will ensure the motor shaft is in the correct parked
position.
19.2
Pre
-
assemble the wiper arm and wiper blade.
19.3
Install the wiper arm onto the wiper motor so that the
wiper is horizontal. See Figure 19.3. Tighten the Set
Screws.
Tools required
2.5mm Allen Wrench
19.4
Adjust the length of the wiper arm as long as possible
while still clearing the outer cap nut for the windshield
latches. Turn on the wiper to check proper operation.
Reference step 5 of the wiper installation instructions.
Fig. 18.1 (Heater Power Connections)
Fig. 19.3 (Wiper Arm and Blade)
Set Screws
Red
Wire
Black
Wire
Orange
Wire
Figure 17.11 (Heater Hose Install)
STEP 17: (HEATER PLUMBING
CONTINUED)
17.11
Install block adapter onto the top of the sending unit
adaptor. Next, install right side
5/8”
heater hose and
1”
hose clamp onto the recently installed block adapter.
Re
-
connect temp. sensor wire to temp. sensor. See
figure 17.11.
17.12
Install left
5/8”
heater hose (cut as needed) and
1”
hose
clamp onto the other block adapter. See figure 17.11.
17.13
Secure all heater hoses from moving parts and
excessive heat sources with the supplied wire ties.
Note: Turn the wheels all the way to the right and left to
ensure adequate clearance between the tires and
hoses. Also, make sure that heater hose routing will not
interfere with loader reinstallation.
17.14
Re
-
install grill and side panels, removed on step 1.9.
Reconnect head light disconnected on step 1.7.
Tools required
12mm Wrench or Socket
Block
Adapter
Right
Hose