curt Triflex Brake Controller, User Manual, Page: 10 / 20

PAGE 10
2. Hold the mounting bracket in the selected position
and mark the hole locations through the bracket.
3. Using a 1/8" diameter bit, drill holes in the marked locations.
4. With a screwdriver or a 1/4" nut driver, secure the bracket in place
using (2) self threading screws (provided). Do not over-tighten.
5. Mount the brake control unit in the bracket using (4) screws.
Wiring
Disconnect the tow vehicle's negative battery terminal
from its battery post before beginning the wiring process.
Most pick-ups and utility vehicles are equipped with a plug from
the factory that allows quick brake control installation. Check the
owner's manual for plug availability, location and installation.
If the mating plug supplied with the vehicle is no longer available, a CURT
quick plug can be used. See the CURT catalog for application information.
For tow vehicles not equipped with a factory brake control plug,
we suggest CURT brake control wiring kit, part# 51500.
Mount a 30 amp, auto reset, circuit breaker as close to the battery as possible.
IMPORTANT: When passing wire through sheet metal, always go
through an existing grommet, add a grommet or use silicone sealer
to protect the wire from sharp edges.